UTS
英
美
abbr. 抗张强度极限；拉力强度（极限）(Ultimate Tensile Strength); 水下电话系统(Underwater Telephone System); 统一传输系统(Unified Transfer System)
双语例句
- It is feasible to forecast the casting UTS by measuring DAS, but the effect of hole ratio on UTS should not be neglected.
通过测定二次枝晶间距来预测铸件的抗拉性能是可行的，但是孔洞率对抗拉强度的影响不可忽视。 - , and YS ( yield strength) and the value of YS/ UTS increase through the followed artificial ageing with obvious loss of elongation.
而其后的人工时效处理能明显提高合金的屈服强度和屈强比，但也明显降低了延伸率。 - The structure homogenization as well as UTS and elongation is related to tempering temperature time, interlayer agent etc.
其组织的均匀程度与抗拉强度、延伸率一样与回火温度、时间及中间层合金的成份有关。 - It is shown that the ultimate tensile strength ( UTS) torsion failure life ( TEL) and reverse bending failure life ( RBFL) are decreased obviously as the consequences of the zincing.
研究结果表明，热镀锌使双相钢冷拔钢丝的抗拉强度、扭转寿命和弯曲寿命降低。 - Inspiration of Teaching Methods on Course of Initiatory Architectural from UTS
悉尼科技大学建筑初步课教学方法启示 - The Unmanned Turret System ( UTS) is the developing direction for future fire system. The UTS is relatively secure to the crew members when the tank and armored vehicle turret is hit with a high probability.
无人炮塔系统是未来火力系统发展的方向，在坦克和装甲车辆炮塔部分被命中概率高的现实情况下，无人炮塔对乘员来说相对安全。 - The improvement of YTS is attributed to the grain refinement strengthening of Y and Zn, and to the solid solution strengthening of Zn. The reduction of UTS and elongation are caused by the precipitation of a compound phase along the grain boundary.
Y、Zn元素的细晶强化及Zn元素的固溶强化是屈服强度提高的主要原因；抗拉强度和延伸率的降低是由于化合物相沿晶界析出。 - In addition, the mechanical properties ( including the UTS value and microhardness) of the welded joints decreased compared to the welded joint without flux.
涂覆活性剂后，焊接接头的力学性能（包括极限抗拉强度和硬度）降低。 - It is suggested that the pressure for solidification mostly affected the early and last dimension of the air holes, and the last dimension of the air hole played an important role for the UTS of the mullite short fibre reinforced Al matrix composites.
结果表明，气孔类残余孔洞初始尺寸和最终尺寸与保压压强有关，并显著影响莫来石短纤维增强铝基复合材料的拉伸强度。 - The output parameters of the model are three mechanical properties namely ultimate tensile strength ( UTS), yield strength ( YS) and elongation ( ELO).
模型的输出为三个力学性能指标，即抗拉强度、屈服强度和延伸率。