slenderness

英 [ˈslɛndənəs]

美 [ˈslɛndərnəs]

网络  细长度; 长细比; 纤细; 名词; 细长

BNC.40473 / COCA.40756

英英释义

noun

• the property of an attractively thin person
  Synonym:slightnessslimness
• relatively small dimension through an object as opposed to its length or width
  1. the tenuity of a hair
  2. the thinness of a rope
  Synonym:thinnesstenuity
• the quality of being slight or inadequate
  1. he knew the slenderness of my wallet
  2. the slenderness of the chances that anything would be done
  3. the slenderness of the evidence

双语例句

• The calculation model of cable tension tested by frequency method for tied-arch bridge is analysed, the effects law of slenderness ratio on calculation precision are also analysed.
  对基于频率法测试系杆拱桥吊杆索力的计算模型的选用进行了研究，重点分析了吊杆长细比对模型计算精度的影响规律。
• The results show that the most remarkable factor is the slenderness ratio, the axial compression ratio takes second place and the steel ratio is third.
  结果表明，对其影响最大的为长细比，其次是轴压比，再次是含钢率。
• In this paper, the bearing capacity and failure modes of long angle steel truss concrete columns with different eccentricities and slenderness ratio are studied.
  本文对不同偏心距和长细比的内含角钢桁架混凝土长柱在偏心荷载作用下的承载力和破坏情况进行了研究。
• Some kinds of Newtons theory of collision methods is extended to calculate the supersonic and hypersonic missiles with large slenderness ratio.
  将牛顿碰撞类方法推广应用于超、高超声速细长体导弹的气动特性预测。
• But the slenderness of that base also means that insolvency threatens when bad times arrive.
  但这个基数的微薄程度也意味着，在市况不好的时候，资不抵债的危险就会出现。
• The displacement ductility of the CFSSTC specimens were analyzed, the effects of the steel ratio, the slenderness ratio, and the axial compression ratio on the ductility of the CFSSTCs were studied.
  同时研究了含钢率、长细比和轴压比对方钢管混凝土柱延性的影响。
• Based on model experiment and simulated experiment, the formula of equivalent slenderness ratio was established.
  在模型试验和仿真试验的基础上，提出了单边连接高强角钢等效长细比公式。
• According to the slenderness ratio and the maximum windward area, four experiments are designed.
  按不同的长细比和不同的最大迎风面积设计了四个实验。
• This article presents a unified analysis of the limiting slenderness of plate elements of compression members with three commonly used sections.
  本文统一分析了轴心压杆三种常用截面的板件宽厚比限值。
• Value Selection of Slenderness Ratio and Diameter-Thickness Ratio of Steel Tube for 1000 kV Transmission Steel Tubular Tower Legs
  特高压钢管塔主材长细比及径厚比的取值