scuffing
英 [ˈskʌfɪŋ]
美 [ˈskʌfɪŋ]
v. 磨损; 磨坏; 拖着脚走
scuff的现在分词
现在分词:scuffing
柯林斯词典
- V-ERG (使)磨损;(使)磨坏
If youscuffsomething or if itscuffs, you mark the surface by scraping it against other things or by scraping other things against it.- Constant wheelchair use will scuff almost any floor surface...
任何地板上经常有轮椅走动几乎都会有所磨损。 - Molded plastic is almost indestructible, but scuffs easily.
注塑几乎弄不坏,但是容易磨损。
- Constant wheelchair use will scuff almost any floor surface...
- VERB 拖着脚走
If youscuffyour feet, you pull them along the ground as you walk.- Polly, bewildered and embarrassed, dropped her head and scuffed her feet.
波莉既困惑又尴尬,低下头拖着脚走开了。
- Polly, bewildered and embarrassed, dropped her head and scuffed her feet.
双语例句
- The maximum load on a bearing should always be smaller than the relief load in order to avoid scuffing.
为了避免划伤,轴承上的最大负荷应该总是小于其卸载负荷。 - There is scuffing and scratching on the bottom surfaces.
有划伤和底部表面划伤。 - My sister was scuffing her feet as we walked down the road.
我们在路上走的时候,我妹妹一直拖着脚步磨蹭。 - The research method adopted in the paper are fo some significance to the study of gear scuffing mechanism and the study to increase the gear scuffing load carry capacity.
本文的研究方法对齿轮胶合机理和提高齿轮胶合承载能力的研究都是有意义的。 - Numerical investigation on interaction of axial and lateral response for super-long pile The maximum load on a bearing should always be smaller than the relief load in order to avoid scuffing.
轴-横向荷载作用下超长桩数值模拟为了避免划伤,轴承上的最大负荷应该总是小于其卸载负荷。 - Study on calculating and test method for gear scuffing
齿轮胶合的计算和试验研究 - This paper provides some theoretical basis for further studying the mechanisms of boundary film formation, wear and scuffing.
这为进一步计算等温应力与热应力场打下了基础,也为研究边界膜成膜,磨损及表面胶合机理提供了一定的理论依据。 - Influence of Lubrication Oil on the Scuffing Resistant of Sliding Friction Pairs
润滑油对滑动摩擦副咬死性能的影响 - Analysis and Calculation of Fuzzy Reliability on Scuffing Resistance of Gear Drive
齿轮传动抗胶合模糊可靠性分析与计算 - The scuffing resistances of three phosphate coatings of manganese are evaluated in a MQ-800 four ball tester equipped with a new wear sample holder.
在MQ&800四球试验机上装配了一种新的磨损试验夹具,评价了三种磷酸锰盐涂层的抗擦伤性能;
