deformations

英 [ˌdiːfɔːˈmeɪʃənz]

美 [ˌdifɔrˈmeɪʃənz]

n.  损形; 变形; 畸形; 破相; 变丑; 残废
deformation的复数

柯林斯词典

• V-ERG （使）变形;（使）成畸形;损毁…的外形
  If somethingdeformsa person's body or something else, it causes it to have an unnatural shape. In technical English, you can also say that the second thingdeforms.
  1. Bad rheumatoid arthritis deforms limbs...
     严重的类风湿性关节炎会造成四肢变形。
  2. ...the ability of a metal to deform to a new shape without cracking.
     金属重新塑形而不断裂的能力

双语例句

• In this paper, the general phenomenon about subsidence and deformations of surface in subway construction is illustrated.
  阐述了城市地铁施工过程中，地表沉陷与变形的一般现象，探讨了地表沉降指数函数计算公式。
• Experimental study on influences of static and cyclic deformations on structural soft clay with stress level
  应力水平对结构性软黏土静力和动力变形特性影响的试验研究
• Objective The aim of this study is to measure the deformations of crowns and the failure loads of cements.
  目的探讨三种不同黏结剂对固定义齿刚性及黏结层破坏负荷的影响。
• Dial gauges, gridding lines and digital camera were used to monitor quantitatively and write down qualitatively the deformations and displacements of the models.
  采用百分表、网格线和数码相机，对模型的变形和位移进行监测和记录。
• Deformable bearings that t ransmit seismic loads limited by plastic deformations or restricted slippage of bearing components;
  传递受到塑性变形或支座构件受限滑移限制的地震荷载的可变形支座；
• Stress, slip, and earthquakes in models of complex single-fault systems incorporating brittle and creep deformations
  具有脆性形变和蠕动变形的复合单断层系模型中的应力、滑动与地震
• Without loss of generality, shear deformations will be neglected.
  不失一般性，忽略不计剪切变形。
• The wing withstands vertical bending, chordwise bending and torsional deformations, and the rotor blade is considered to be capable of rigidly withstanding one order flap and lag motions.
  机翼承受垂向弯曲、弦向弯曲和扭转变形，螺旋桨旋翼的桨叶认为是刚性的并承受一阶挥舞和摆振。
• Special attention is given to the effect of reinforcement on delayed deformations and on the stability of the embankments and foundations.
  特别研究了土工织布加固对堤坝下软土的滞后变形和稳定性的影响。
• Then the door deformations in X and Y directions are analyzed with both theoretical and real gaps.
  分别对车门在理论间隙和实测间隙下的Y向变形、X向变形进行分析。